Pneumatic Actuator – How to install it ? - Guide by Kinetrol Pneumatic actuators

The actuators can be divided into two types and are based on technical principle of the valves, and they are made up with electric and pneumatic actuators.

The structure of pneumatic actuators are a type of quarter-turn structure used to regulate coupled with the locators of the pneumatic actuators.

They are also suitable in gas, steam and liquid, etc  and it consists of valve bodies, pneumatic operating mechanism, locators, and other accessories.

When it comes to the operating system of the Kinetrol pneumatic actuators, it adopts the power source of compacted gas and turns the arms through the mobility of the valves.

The installation of the ball actuators with pneumatic actuators:

1.      The process starts with dismantling the protecting lids on both sides of the ends and rinsing the valves under the situation of full opening of the valve.

2.      Before the process, we recommend you to check the valves with pneumatic actuators according to the delegated signals and if no issues are found, then you can put them into installation.

3.      Prior to connecting, it is crucial to wash clearly the pipes to ensure there are no residues left in the pipes and also these residues can erode the balls and valves.

4.      Installation of pneumatic actuators can be either in a horizontal or vertical direction of the pipes.

5.      During the installation process, the structure of operations should not be used as the lifting point in the whole process to avoid any damages.

6.      Finally, look closely the flanged joint screw.

At last, we recommend you to test the actuators with Kinetrol pneumatic actuators to see if they are working properly and safety.

Now that you know how to install actuators and check it using Kinetrol pneumatic actuators, make sure to visit our official website now for more information!